Cast Iron ANSI brass seated Gate Valve

Quick Detail：

150LBS metal seated flanged gate valve with NRS

Design standard: AWWA C515

Non rising stem

Body material: ductile iron A536

Wedge: Ductile iron + Bronze

Stem：stainless steel 410

Nominal diameter:6",

Pressure: 150LBS

End connection: FLXFL flanged ends

Face to face: AWWA ANSI B16.10

Working temperature: -30℃~+200℃.

Test and inspection: API 598.

Red color epoxy powder coated Min. 250 Microns.

Scope and Performance?

This standard of AWWA C500 describes iron-body, metal-to-metal seated, non rising
stem (NRS) gate valves, including tapping gate valves, 3 in. (75 mm) through?
72 in. (1,800 mm), and outside screw and yoke (OS&Y) rising-stem gate valves,?
3 in. (75 mm) through 72 in. (1,650 mm), with either double-disc gates having? parallel or inclined seats, or solid-wedge gates.

These valves are suitable for use in approximately level settings within water systems.

These valves are intended for applications where fluid velocities do not exceed 16 ft/sec (4.9 m/sec) when the?
valve is in the fully open position.

Valve pressure ratings.

The minimum design working water pressure shall be 200 psig (1,379 kPa) for valves 12 in. (300 mm) and smaller,?
and 150 psig (1,034 kPa) for valves with diameters of 14 in. (350 mm) and larger.

Applicaiton reminder:

This standard is not intended to describe special conditions of gate-valve installation or operation,?
such as built-in power drive, installation in unusually corrosive soil, conveyance? of unusually corrosive water, excessive water hammer, or operation in a throttled? position. Such conditions are beyond the intended scope of this standard and?

?